Most of the experienced welders have been using the inverter type of welders to their kits for many reasons. One of those reasons is that, they could generate a good amount of power, once they’re plugged into a standard household power. This simply gives the user a good deal of flexibility to weld in places whey 220v power isn’t really available. Another thing is that, they aren’t susceptible to low quality power. Thus, you must be fine running them of any kind of generator. 

The inverter welders are relatively small, so you can easily carry it wherever you want to go. This will surely let you move faster and get into smaller places wherein the standard welder would never surely fit. However, the downsides of this type of welder can only perform well with the high-tech electronic components. Thus, it only means that they cost somewhat higher for the same power, and has to be treated carefully, for the reason that they should not be rugged, compared to those conventional welders you used.

On the other hand, since these kinds of welders only use less power, the power bill will never be an issue for your manufacturing facility or shop. You just have to change your welders and you could surely save in the long run. It’s just that, the inverter types will not be right for all jobs, so the best combination is that, you should keep your conventional welders and get this one and use them both.

When you’re dealing with a non operational inverter type of welder, the first step for you to recover it simply involves the Pre-power check performance. This involves discrete component tests, which has to be performed before the unit being powered up. It is also an essential process for you to perform, for the reason that those shorted internal components will likely to explode whenever the voltage is applied to it. 

When it comes to performing a pre-power checking, you need to turn off the welder and that you must never rely on the power switch alone. So, the unit has to be unplugged from the wall without the input voltage applied from the main switch. It’s also advised for one to wait for a couple of minutes for all of the internal Filter Capacitors to discharge. The time actually varies, and is somewhat based on the time constant of the bleed resistors as well as capacitors.

If you want to use inverter welders for your business, knowing everything about it first will be ideal. This is for the safety of the users and also, for an additional knowledge of using this modern type welder machine.